Sprint Nextel U727 Modem User Manual


 
Section 2C: Menu Options 93
EVDO Only: Select the EVDO Only option if you would like to
have Sprint Mobile Broadband connect to only 1xEV-DO
networks. You can disable EVDO Mode at any time if you are
not connected to any network by selecting another option.
1xRTT Only: Select the 1xRTT Only option if you would like to
have Sprint Mobile Broadband connect to only 1xRTT
networks. When you apply this option, the next time you make
a connection Sprint Mobile Broadband will search for only
1xRTT networks.
Applying your Mode Preference
1. Click OK or Apply on the Settings dialog box to reset your
device. When you apply your service preference the following
dialog will appear: “Service setting was changed successfully.
Please wait while the modem is reset for the changes to take
effect.”
2. Click OK to close the dialog box. When the device is reset the
Go button will be visible and the Sprint Mobile Broadband
user interface will display “Disconnected.” This may take a
moment.
Note:
Sprint Mobile Broadband will always try to connect to a Sprint
CDMA 1xEV-DO network first before attempting to connect
to a 1xRTT network. 1xEV-DO networks always have priority!
If a 1xEV-DO network is unavailable then Sprint Mobile
Broadband will search for an available 1xRTT network.
Tip:
If the signal strength is too weak and you are unable to
connect using 1xRTT in the 1900 MHz frequency, or if your
connection fails due to this selection, disable the setting.