Filter
Top Products
18
Operating
LASER
INDICATOR
MY SOURCE/
DOC.CAMERA
STANDBY/ON VIDEO RGB
ON
OFF
1
2
+
-
FREEZE KEYSTONE MUTE
Temporarily muting the sound
ESC MENU RESET
POSITION AUTO
MAGNIFY
ON
OFF
MY BUTTON
1
2
VOLUME
+
-
RGB 1 RGB 2 HDMI MIU
VIDEO S-VIDEO COMPONENT (Y, CB/PB, CR/PR)
Operating
1.
Use the VOLUME + / VOLUME - buttons to adjust the
volume.
A dialog will appear on the screen to aid you in adjusting the
volume.If you do not do anything, the dialog will automatically
disappear after a few seconds.
Adjusting the volume
● When is selected for current picture input port, the volume adjustment is
disabled. Please see AUDIO item of AUDIO menu (
38).
● When the projector is in the standby mode, the volume can be adjusted if
is
not selected for the AUDIO OUT STANDBY of AUDIO (
38).
1.
Press MUTE button on the remote control.
A dialog will appear on the screen indicating that you have
muted the sound.
To restore the sound, press the
MUTE, VOLUME + or
VOLUME - button. Even if you do not do anything, the dialog
will automatically disappear after a few seconds.
1.
Press the INPUT button on the projector.
Each time you press the button, the projector switches its
input from the current port as below.
Selecting an input signal
RGB 1 RGB 2 HDMI MIU
1.
Press the RGB button on the remote control to select an
input port for the RGB signal.
Each time you press the button, the projector switches its
RGB input from the current port as below.
●
While TURN ON is selected for AUTO SEARCH item in OPTION menu,
the projector will keep checking every port sequentially till aninput signal
is detected
(
44)
. If RGB button is pushed when VIDEO, S-VIDEO or
COMPONENT port is selected, the projector will check RGB1 port first.
(continued on next page)
●
When is selected for current picture input port, the sound is always muted.
Please see AUDIO item of AUDIO menu
(
38)
.
●
When the sound is muted while a signal from VIDEO(NTSC),
S-VIDEO(NTSC) or COMPONENT(480i@60) port is selected, the C.C.
(Closed Caption) is automatically activated if the DISPLAY item of the C.C.
menu is set to AUTO and the input signal supports the C.C. feature (64).