Filter
Top Products
42
SCREEN menu
SCREEN menu (continued)
Item Description
MESSAGE
Using the ▲/▼ buttons turns on/off the message function.
TURN ON
TURN OFF
When the TURN ON is selected, the following message function works.
“AUTO IN PROGRESS” while automatically adjusting
“NO INPUT IS DETECTED”
“SYNC IS OUT OF RANGE”
“INVALID SCAN FREQ”
“Searching….” while searching for the input
“Detecting….” while an input signal is detected
The indication of the input signal displayed by changing
The indication of the aspect ratio displayed by changing
The indication of the PICTURE MODE displayed by changing
The indication of the ACTIVE IRIS displayed by changing
The indication of the MY MEMORY displayed by changing
The indication of “FREEZE” and “II” while freezing the screen by
pressing the
FREEZE button.
• When the TURN OFF is selected, please remember if the picture
is freezing. Do not mistake freezing for a malfunction (
22).
SOURCE NAME
Each input port for this projector can have a name applied to it.
(1) Use the
▲/▼
buttons on the SCREEN menu to
select SOURCE NAME and press the
►
button.
The SOURCE NAME menu will be displayed.
(2) Use the ▲/▼ buttons on the SOURCE
NAME menu to select the port to be named
and press the ► button. Right side of the
menu is blank until a name is specified.
The SOURCE NAME dialog will be displayed.
(3) The current name will be displayed on
the first line. Use the
▲/▼/◄/►
buttons
and the
ENTER or INPUT button to select and
enter characters. The
RESET button can be
used to erase 1 character at a time. Also if you
move the cursor to DELETE or ALL CLEAR on
screen and push the
ENTER or INPUT button,
1 character or all characters will be erased. The
name can be a maximum of 16 characters.
(4) To change an already inserted character,
press the
▲
button to move the cursor to the
first line, and use the
◄/►
buttons to move
the cursor on the character to be changed.
After pressing the
ENTER or INPUT button, the
character is selected. Then, follow the same
procedure as described at the item (3) above.
(5) To finish entering text, move the cursor to the
SAVE on screen and press the
ENTER or INPUT button. To revert to the
previous name without saving changes, move the cursor to the CANCEL on
screen and press the
ENTER or INPUT button.
(continued on next page)