Filter
Top Products
115
Automatic fanfold feeding
❏ See “Loading paper” on page 15 for details on
using fanfold paper.
Manual sheet feeding
You can use the following procedure to manually
feed single sheets of paper into the printer.
❏ Make sure that there is no fanfold paper in the
printer. If there is, use the procedure under
“Parking fanfold paper” on page 21 to park the
fanfold paper and prepare for manual sheet
feeding.
❏ Set the release lever to the cut-sheet position.
❏ Reposition the paper guide so it is standing up
and adjust the guides to match the width of the
paper.
❏ Insert a sheet of paper into the paper guide, with
the side you want to print on facing the back of
the printer. Gently push the paper down into the
printer until you feel it stop.
❏ Pull the bail lever toward the front of the printer.
This will feed the paper to the starting position.
❏ After the paper is fully fed (indicated by the
printer’s beeping), return the bail lever back to its
original position toward the back of the printer.
❏ If you want to move the paper to another
position, use the micro feed function described
under “Micro feed” on page 33.
❏ Start the printing operation from your software
application.
Important!
Never return the bail lever back to its original
position until the paper is fully fed. The printer will
beep to let you know when you can return the bail
lever to its original position.
Cut-sheet
Feuilles séparées
Einzelblatt
Carta in fogli
Fanfold
Papier continu
Endlospapier
Carta in modulo continuo
Paper guide
Guide-papier
Papierführung
Guida della carta
Release lever
Levier de dégagement
Papierwahlschalter
Leva di rilascio
LOAD
Bail lever
Levier du presse-papier
Freigabehebel
Leva libera-carta