Filter
Top Products
Figure 4-l shows the recommended print area for each type of papers.
IX
Fanfold forms
Single sheets
20 mm
m
5mm Smm
23 mm
c*XO mm for Push Feed)
-
-
Figuru 41. Recommended print area for acceptable papers.
ADJUSTING THE PRINTING GAP
The distance between the print head and the platen can be adjusted to
-
accommodate different paper thicknesses. To make this adjustment, open the
-
front cover. The adjustment lever is located at the left side of the printer
_
mechanism. Pushing the adjustment lever backwards narrows the gap;
pulling it forwards widens the gap.
There are seven positions, and you can feel the l&er clicking into each
position. The second position from the rear (marked with “m”) is the one most
commonly used for single sheets of paper.
Try different positions until you get the best printing results.
NOTE:Printing with an inappropriate gap may drastically shorten the life
of the print head.
26