Filter
Top Products
l Auto On-Line
Set the status just after loaded the paper into the printer.
When the Auto-Online is set [*ENABLED], the printer automatically goes
on-line.
When it is set [DISABLED], you must press the 1
ON LINE I button to set
on-line after load the paper.
l STROBE timing
. .
This switch controls the timing of the interface.
Most computers can communicate with the Normal timing, as the factory-
setting, [*NORMAL].
If you were not possible to communicate with your computer to the printer,
set this switch to [REVERSE].
Font menu
The Font menu allows you to set two parameters concerning fonts which will
be automatically selected whenever you turn on the printer.
l Zero style
This menu tells the printer how to print zero’s.
When the [*NORMAL] is selected, the printer prints the normal zero; when
it is [SLASHED], the slash zero (which is often used in draft mode to prevent
any possible confusion with the letter “0”).
l NLQ Font
.
There are many font styles for NLQ print mode. You can select one of them
as the power-on default by setting this switch.
NOTE:Since there are many fonts you can select, the [OTHER] option
indicates to select other options on the next line.
Character menu
The Character menu allows you to select the character set which will be
printed.
l Standard Character Table
If you selected Standard mode, you can set either italic or graphic
characters.
When you select the [ITALIC] characters, the character table is the same as
the Epson printers.
When you select the [*GRAPHICS] characters, in place of italics you will
get the graphic characters, international characters, and mathematical
symbols of IBM character set #2.
59