Filter
Top Products
Clamp lever
Pull tractor unit
ractor cover
Figum 4-O. Mount the fanfdd paper to the Pull Tractor Unit by turntng
ttm platen KtIOD.
12. Adjust the spacing of the optional tractor units by sliding them along the
bar, using the clamp lever at the back of each unit to release and lock them
in position. When the lever is up, the unit is released, and when it is down,
the unit is locked.
13. Now close the tractor covets, again making sure that the paper holes are
aligned with the pins on the optional tractor units. If they are not aligned
properly, you will have problems with paper feeding, possibly resulting
in tearing and jamming of the paper.
14. Remove the lever stopper from the slot of the release lever as shown in
Figure 4-10.
15. Set the release lever to the
“a” position, and turn the platen knob
clockwise to tighten the paper if it is slack.