Filter
Top Products
Chapter 1: Introduction
1-3
Processors
The P4SC8 supports a single Intel® Pentium® 4 processor (with a 2MB
integrated transfer cache) of up to 3.40 GHz with hyper-threading technol-
ogy in a 478-pin microPGA socket (processors up to 3.20 GHz must be 90
nano or 0.13 micron technology) or a single Intel® Celeron® processor
(with a 128KB integrated advanced transfer cache) of up to 2.80 GHz.
Please refer to the support section of our web site for a complete listing of
supported processors (http://www.supermicro.com/support/).
Memory
The P4SC8 has four (4) 184-pin DIMM sockets that can support up to 4 GB
of ECC unbuffered DDR400/333/266 SDRAM modules. Low-profile memory
modules are required for use in the 1U form factor of the 5013C-M8. Mod-
ule sizes of 128 MB, 256 MB, 512 MB and 1 GB may be used to populate the
DIMM slots. All memory modules should be the same size and speed.
SCSI Subsystem
The E7210's on-chip SCSI controller supports four 80-pin SCA Ultra320 SCSI
hard drives. (Standard 1" drives are supported. SCA = Single Connection
Attachment.) The SCSI drives are connected to an SCA backplane that provides
power, bus termination and configuration settings. The SCSI drives are also hot-
swap units.
PCI Expansion Slots
The P4SC8 has two 32-bit, 33 MHz (5V) PCI slots and two 64-bit, 66 MHz (3.3V)
PCI-X slots. When configured as the 5013C-M8, one 66 MHz PCI-X slot is
available with the use of a riser card (included with the system).
Ethernet Ports
The P4SC8 has an onboard controller that supports two Gigabit LAN ports.
Onboard Controllers/Ports
An onboard IDE controller supports up to four Ultra ATA 100 hard drives or ATAPI
devices. Onboard I/O backpanel ports include one COM port, one parallel (printer)
port, a VGA port, two USB ports, PS/2 mouse and keyboard ports and two GLAN
(NIC) ports.