Filter
Top Products
7-6
SUPERSERVER 5013C-M8 User's Manual
7-4.2 Advanced Chipset Control
Access the submenu to make changes to the following settings.
ECC Configuration
This setting allows you to enable or disable ECC (Error Correction and Checking).
The options are "ECC" and "Non-ECC".
CSA LAN (Gigabit LAN)
Select "Enabled" to activate the CSA LAN. The options are "Enabled" and
"Disabled".
On-Chip Serial ATA
This setting allows you to configure On-Chip Chipset Configurations. Select
"Disabled" to disable the SATA controller. If "Auto" is selected, BIOS will
automatically configure the settings for SATA controller. Select "Combined
Mode" to combine both Parallel ATA (PATA) and Serial ATA (SATA) functions
(with a maximum of two IDE drives available for each channel.) If "Enhanced
Mode" is selected, both SATA and PATA are supported (with a maximum of six
IDE drives available.) If "SATA Only" is selected, SATA will operate in the Legacy
Mode. The options are "Disabled", "Auto", "Combined Mode", "Enhanced Mode"
and "SATA only".
Serial ATA Port0/1 mode
This setting allows you to configure Serial ATA Port0/1 modes. The options are
"Primary Master", "Primary Slave", "Secondary Master", "Secondary Slave",
"SATA0 Master" and "SATA1 Master".
SATA Mode
This setting allows you to set the SATA Mode RAID via BIOS. The options
are "RAID" and "IDE".