Filter
Top Products
7-8
SUPERSERVER 5013C-M8 User's Manual
UART Mode Select
This setting allows the user to select the UART mode for the BIOS. The options
are "IrDA", "ASKIR" and "Normal".
RxD, TxD Active
This allows the user to change the settings for the "RxD, TxD Active" function.
The options are "Hi, Hi", "Hi, Lo", "Lo, Hi" and "Lo, Lo".
IR Transmission Delay
If "Enabled", the transmission of IR (infrared) signals will be delayed. The options
are "Enabled" and "Disabled".
UR2 Duplex Mode
This setting sets the UR2 Duplex Mode. The options are "Full" and "Half".
Use IR Pins
This item sets the usage of the IR pins. The options are "RxD2, TxD2" and "IR-
Rx2Tx2".
Onboard Parallel Port
This setting allows the user to set the address and the corresponding IRQ for the
onboard parallel port. The options are "Disabled", "378/IRQ7", "278/IRQ5" and
"3BC/IRQ7".
Parallel Port Mode
This setting sets the mode for the onboard Parallel port. The options are "SPP,"
"EPP", "ECP" "ECP+EPP" and "Normal".
EPP Mode Select
This setting allows the user to select the EPP port type. The options are "EPP
1.9" and "EPP 1.7".
ECP Mode Use DMA
This setting allows the user to select the DMA channel for the ECP mode (port)
to use. The options are "1" and "3".
Watch Dog Timer Select
This setting allows you to select the setting for the Watch Dog Timer. The
options are "Disabled", "10 Sec", "20 Sec", "30 Sec", "40 Sec", "1 min", "2 min"
and "4 min".