SUPER MICRO Computer X7SLA-L Computer Hardware User Manual


 
Chapter 4: AMI BIOS
4-7
Advanced Chipset Control
The items included in the Advanced Settings submenu are listed below:
NorthBridgeConguration
This feature allows the user to congure the settings for the Intel 945GC North-
Bridge.
DRAM Frequency
This feature allows the user to select the DRAM Frequency setting. The options
are Auto (Auto-detect), 400 MHz and 533 MHz.
CongureDRAMTimingbySPD
Select Enable to allow the BIOS to read the SPD (Serial Presence Detect) chip
which is built in the memory module in order to get the exact memory specica-
tions. The options are Enabled and Disabled.
Memory Hole
Use the feature to allocate memory resource reserved for use of PCI devices. If
set to 15 MB~16MB, the reserved memory will be placed in the location around
15 MB~16 MB. The options are Disabled and 15 MB~ 16 MB.
Initiate Graphic Adapter
Use the feature to select the graphics controller to be used as the primary boot
device. The options are IGD, PCI/IGD, PCI/PEG, PEG/IGD, and PEG/PCI.
Internal Graphics Device Mode Select
Use the feature to set the amount of system memory to be used by the Internal
Graphics Devices. The options are Disabled, Enabled, 1 MB and Enabled, 8
MB.
PEGPortConguration
PEG Port
Use the feature to congure the PEG Port. The Default setting is Auto to
allow the PEG Port to be automatically detected and congured by the BIOS.
The options are Auto and Disabled.
PEG Force x1
If set to Enabled, PEG will be congured to x1 setting by the BIOS. The
options are Enabled, and Disabled.