Filter
Top Products
Add the same credentials that you already use in your environment.
Another procedure exists to add a load balancing server to your configuration.
See “Adding a load balancing server” on page 58.
Toadd NetBackupDeduplication Enginecredentials byusingthe tpconfigcommand
◆
Onthe hostto whichyou wanttoadd credentials,run thefollowing command:
UNIX: /usr/openv/volmgr/bin/tpconfig -add -storage_server
sshostname -stype PureDisk -sts_user_id UserID -password PassWord
Windows: install_path\Veritas\NetBackup\Volmgr\bin\tpconfig -add
-storage_server sshostname -stype PureDisk -sts_user_id UserID
-password PassWord
For sshostname, use the name of the storage server.
Changing NetBackup Deduplication Engine credentials
You cannot change the NetBackup Deduplication Engine credentials after you
enter them. If you must change the credentials, contact your Symantec support
representative.
See “About NetBackup Deduplication Engine credentials” on page 26.
Deleting credentials from a load balancing server
You may need to delete the NetBackup Deduplication Engine credentials from a
loadbalancing server.For example, disasterrecovery mayrequire that youdelete
the credentials on a load balancing server.
Another procedure exists to remove a load balancingserver from a deduplication
node.
See “Removing a load balancing server” on page 70.
To delete credentials from a load balancing server
◆
On the load balancing server, run the following command:
UNIX: /usr/openv/volmgr/bin/tpconfig -delete -storage_server
sshostname -stype PureDisk -sts_user_id UserID
Windows:install_path\Veritas\NetBackup\Volmgr\bin\tpconfig -delete
-storage_server sshostname -stype PureDisk -sts_user_id UserID
For sshostname, use the name of the storage server.
75Managing deduplication
Managing NetBackup Deduplication Engine credentials