Filter
Top Products
35
Test-Um NT955 Series
1.6. Calibrate
The calibration procedure is performed to set a reference point for cable
length to 0 feet/meters. Once calibration is performed, the test unit
retains the information. The Validator-NT does not require any other
calibration. (Figure 1.7)
Note: Please disconnect all Patch Cables
Calibrate
Untitled1.job
Continue
To calibrate the unit make sure there are no
cables plugged into the unit. (Unless a patch
cord is being used)
Test-Um Inc.
validator
100%
2005 Aug 25
10:53:01
Figure 1.7 Calibrating The Unit
Validator
TM
Setting Up the Test ToolValidator
TM
Setting Up the Test Tool