Filter
Top Products
4- 3
EO1-33038
4. INSTALLING THE PRINTER
4.2 INSTALLING THE MEDIA GUIDE
4.2 INSTALLING THE MEDIA GUIDE
A cutter is attached to the inside of the media cover. Care should be taken
not to injure your hand with the cutter when opening the cover.
NOTE: The media guides are not required for a 58 mm wide media roll.
1) Slide the media cover release catches inside and open the media cover.
2) Fit one media guide into the media holder's edge of the operation panel
side, and the other one into a groove which corresponds to the width of
media to be used. First insert side (1), then (2) until it snaps in position.
NOTE:Be sure to fit the media guide in parallel with the grooves.
Media Cover
Media Cover
Release Catch
(2)
(1)
WARNING!
Media Guide
Media Holder
Operation Panel Side