Filter
Top Products
- 241 -
oo: 1st byte code of the control code
(*2)
“00” to “FF” (Specify the hex code in 2 bytes of ASCII code.)
(*3)
pp: 2nd byte code of the control code
(*2)
“00” to “FF” (Specify the hex code in 2 bytes of ASCII code.)
(*3)
qq: 3rd byte code of the control code
(*2)
“00” to “FF” (Specify the hex code in 2 bytes of ASCII code.)
(*3)
r: Peel-off wait status selection
0: OFF (No peel-off wait status selection)
1: ON (Peel-off wait status selection)
s: [FEED] key function
0: FEED: Feeds one label.
1: PRINT: Prints data of the image buffer on one label.
t: Kanji code selection
0: TYPE1
1: TYPE2
uu: Euro code setting
“20” to “FF” (Specify the hex code in 2 bytes of ASCII code)
(*3)
v: Automatic head broken dots check
0: OFF (When the power is turned on, the broken dots check is not
automatically performed.)
1: ON (When the power is turned on, the broken dots check is automatically
performed.)
w: Centronics ACK/BUSY timing setting
0: TYPE1
1: TYPE2
x: Web printer function setting
0: OFF (Web printer function is disabled.)
1: ON (Web printer function is enabled.)
y: Reset process when the nInit signal is ON
0: OFF (Reset process is not performed.)
1: ON (Reset process is performed.)
z: Ribbon near end detection setting
0: Not detected.
1: Detected when the remaining length of the ribbon is 30 m.
2: Detected when the remaining length of the ribbon is 70 m.
A: Expansion I/O operation mode setting
0: Standard mode
1: In-line mode
B: Centronics operation mode setting
0: SPP (Compatibility mode)
1: ECP (ECP mode)