Filter
Top Products
- 51 -
6.3.3 PRINT DENSITY FINE ADJUST COMMAND [ESC] AY
Function Adjusts the automatically set print density.
Format [ESC] AY; abb, c [LF] [NUL]
Term a: Indicates whether to increase or decrease the density.
+: Increase (darker)
-: Decrease (lighter)
bb: Print density fine adjustment value
00 to 10 (in units of 1 step)
c: Indicates the mode for fine adjustment, thermal transfer or direct thermal.
0: Thermal transfer
1: Direct thermal
Explanation (1) The print density fine adjustment is performed by adjusting the time that the
voltage is applied to the thermal head.
(2) If the print density fine adjustment value has been set in system mode (key
operation on the printer), the fine adjustment value will be the sum of the fine
adjustment by this command and the fine adjustment in the system mode. The
maximum fine adjustment values for thermal transfer/direct thermal print modes
are each ±10.
(3) The fine adjustment values in thermal transfer print mode and direct thermal print
mode can be set independently.
(4) The Print Density Fine Adjust Command is protected in memory (even if the power
is turned off).
(5) The fine adjustment value for both the fine adjust command and the system mode
fine adjustment is 00 at shipment from the factory.
(6) The maximum value for each print speed is as follows. When the value exceeds
the maximum, it is automatically corrected to the max. value, and then the printer
prints.
B-SX4T B-SX5T
V1 type: TPH104R2 V2 type: TPH104R7 V1 type: TPH128R4 V2 type: TPH128R5
Print
speed
Thermal
direct
Thermal
transfer
Thermal
direct
Thermal
transfer
Thermal
direct
Thermal
transfer
Thermal
direct
Thermal
transfer
3 ips +10 step +10 step +10 step +10 step +10 step +10 step +10 step +10 step
5 ips ---- ---- ---- ---- +7 step +10 step +7 step +10 step
6 ips +8 step +8 step +8 step +8 step ---- ---- ---- ----
8 ips ---- ---- ---- ---- +3 step +10 step +3 step +10 step
10 ips +4 step +8 step +5 step +7 step ---- ---- ---- ----
Examples To set the density in thermal transfer print mode to -2.
[ESC] AY; -02, 0 [LF] [NUL]
To set the density in direct thermal print mode to +3.
[ESC] AY; +03, 1 [LF] [NUL]