Toshiba BSX4TGS20QMR Printer User Manual


 
- 263 -
(2) Cutter Error
Rotary cutter
When the cutter does not move from the cutter home position 40 msec or more after the cutter
solenoid is driven, an error will result.
The cutter moves from the home position, however, it does not return to the home position after
150 msec.
Swing cutter
When the cutter home position sensor does not detect 1.5 sec or more after the cutter motor is
driven, an error will result.
• A paper jam has occurred at the cutter. (The cutter does not return to the home position.)
• The cutter does not move from the home position.
• The cutter cover is open.
(3) Label End
Error processing differs depending on the setting of label end/ribbon end process in the system
mode.
When TYP1 is selected. (default):
c When the transmissive sensor or the reflective sensor detects a continuous 3-mm long label
end state, an error will result.
d When an issue, a feed, or an ejection is attempted in a printer stop state while the
transmissive sensor or the reflective sensor detects the label end state, an error will result.
When TYP2 is selected. (effective only when the ribbon saving function is not used.):
c When the transmissive sensor or the reflective sensor detects a continuous 3-mm long label
end state, the printer completes the printing of half-finished label, and then an error will result
when the next label is at the home position.
d When an issue, a feed, or an ejection is attempted in a printer stop state while the
transmissive sensor or the reflective sensor detects the label end state, an error will result.
(4) Ribbon End
Error processing differs depending on the setting of label end/ribbon end process in the system
mode.
When TYP1 is selected. (default):
c With the ribbon being selected, when the ribbon end sensor detects a continuous 5-mm long
ribbon end state, an error will result.
d With the ribbon being selected, when an issue, a feed, or an ejection is attempted in a printer
stop state while the ribbon end sensor detects the ribbon end state, an error will result.
When TYP2 is selected. (effective only when the ribbon saving function is not used.)
c With the ribbon being selected, when the ribbon end sensor detects a continuous 5-mm long
ribbon end state, the following process depends on the unfinished label length as follows.
When unfinished label length is 30 mm or more, an error results after the printer prints
the label for 20 mm.
When unfinished label length is less than 30 mm, the printer completes the half-finished
label and stops printing when the next label is at the home position.
d With the ribbon being selected, when an issue, a feed, or an ejection is attempted in a printer
stop state while the ribbon end sensor detects the ribbon end state, an error will result.