Filter
Top Products
- 244 -
o: Fine adjustment direction for the ribbon back tension motor voltage
-: Negative (The voltage is lowered.)
pp: Fine adjustment value for the ribbon back tension motor voltage
00 to 15 (in units of 1 step)
qq: Reflective sensor manual threshold fine adjustment value
00 to 40 (in units of 0.1 V)
rr: Transmissive sensor manual threshold fine adjustment value
00 to 40 (in units of 0.1 V)
Explanation (1) This command is not executed until the printer enters an idle state.
(2) With some exceptions, the parameters set by this command take effect when the
power is turned on or the printer is reset.
*1: The value can be set in units of 0.1 mm. However, the value which is actually set
on the printer is in units of 0.5 mm. When a value from 0.0 mm to 0.4 mm is set, it
is actually set on the printer as 0.0 mm. Also when a value from 0.5 mm to 0.9
mm is set, it is actually set on the printer as 0.5 mm.