Filter
Top Products
45
RS485/232 Port Configuration
Figure 26: Edit Port Configuration
• Edit Protocol Selection: Menu selection 1 allows you to change
what serial protocol is running on the selected port. Note that not all
ports run the same protocols. Figure 26 shows an example of
changing the protocol selection on the RS485 port from Disabled to
Modbus Slave.
• Edit Baudrate: Menu selection 2 allows you to change the baudrate
for the selected port. Note that the baudrate for some protocols is
determined by the specification, and these will therefore ignore this
setting.
• Edit Parity: Menu selection 3 allows you to change the parity for the
selected port. Note that the parity for some protocols is determined by
the specification, and these will therefore ignore this setting.
• Edit address: Menu selection 4 allows you to edit the network
address that the selected port will respond to. This setting is
applicable for slave protocols only.
• Edit Timeout: Menu selection 5 allows you to edit the timeout time
for the selected port. Refer to section 13.2 for more information on
timeout processing.