Filter
Top Products
4 Replacement Procedures 4.12 MDC / Modem cable
4-32 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)
Installing the MDC / Modem cable
The following describes the procedure for installing an MDC / Modem cable. (See Figure 4-
17 and 4-18.)
1. Connect the Modem cable to the connector CN3001 on the system board.
2. Secure the drain cable 2 to the stud of hinge assembly with the following screw.
• M2.0x4.0Z BIND screw x1
3. Arrange the Modem cable inside the insulators and close the insulators.
4. Arrange the Modem cable along the guide of mini PCI cover.
5. Secure the drain cable 1 to the stud of system board with the following screw.
• M2.0x4.0Z BIND screw x1
or
• M2.0x4.0B LH STICK x1
6. Connect the Modem cable to the connector of MDC.
7. Install the MDC to the connector CN3000 on the system board and secure it with the
following screws.
• M2.0x4.0Z BIND screw x2
8. Stick the glass tape on the Modem cable.