Filter
Top Products
4 Replacement Procedures 4.26 LCD unit & FL inverter
4.26 LCD unit & FL inverter
Removing the LCD unit & FL inverter
The following describes the procedure for removing the LCD unit & FL inverter. (See Figure
4-38 to 4-41.)
NOTE: When replacing the LCD unit, do not give the hinge portion a strong press. It may
cause the breakage of the hinge assembly.
Also, Use a stand or something under the LCD part to keep the LCD part level
while replacing it.
1. Peel off the mask seals (6 points) from the LCD mask.
2. Remove the following screws securing the LCD mask.
• M2.5x6.0S FLAT BIND screw x6
3. Laying down the LCD unit and the cover assembly flat, release the latches to remove
the LCD mask.
4. Remove the cross function button from the application switch board.
NOTE: When removing the LCD mask, be careful not to lose the cross function button
because the button is easily removed.
Cross function button
M2.5x6.0S FLAT BIND
M2.5x6.0S FLAT BIND
LCD mask
Figure 4-38 Removing the LCD mask
4-60 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)