Filter
Top Products
4 Replacement Procedures 4.30 LCD harnesses & Wireless LAN/Bluetooth antennas
4-72 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)
4.30 LCD harnesses & Wireless LAN/Bluetooth antennas
Removing the LCD harnesses & Wireless LAN/Bluetooth antennas
The following describes the procedure for removing the LCD harness & wireless
LAN/Bluetooth antennas. (See Figure 4-45 and 4-46.)
1. Pull out the wireless LAN antenna cables / Bluetooth antenna cable from the guide.
2. Remove the following screws and LCD harness holder.
• M2.5x2.8B FLAT BIND screw x1
3. Remove the following screws and digitizer harness holder.
• Unique screw CPU stud screw x1
• M2.5x6.0S PSP TIGHT screw x1
4. Remove the following screws securing the hinge assembly.
• M2.5x6.0B FLAT BIND screw x1
• M2.5x6.0S PSP TIGHT screw x1
5. Remove the hinge rear cover from the hinge assembly.