Filter
Top Products
Additional information 32
2. Loosen the screws on the lamp cover.
The lamp door is on the side of the projector.
3. Remove the lamp cover.
4. Loosen the screws that hold the lamp to the projector. It is strongly
recommended that you use a magnetic-head screwdriver to prevent
the screws from dropping inside the projector.
5. Slowly pull the lamp straight out of the projector.
Pulling it too quickly may cause the lamp to break and scatter broken glass in
the projector. To reduce the risk of injuries to fingers and damage to internal
components, use caution when removing lamp glass that has shattered.
Do not place the lamp in locations where water might splash on it, where
children can reach it, near or above heat sources, or near flammable materials.
Do not insert your hands into the projector after the lamp is removed. Touching
the optical components inside the projector can cause color unevenness and distortion of the
projected images.
6. Insert a new lamp. Make sure it is securely in place.
7. Tighten the screws securing the lamp box.
8. Reinstall the lamp cover.
9. Tighten the screws on the lamp cover.
Do not over-tighten the screws.
Loose screws may cause a bad connection, which could result in
malfunction.
10. Turn the power on. Open the Setup > Lamp > Reset Lamp
Timer menu to reset the lamp time.
Do not turn the power on with the lamp cover removed.
Whenever the lamp is replaced, reset the total lamp operation time.
Do not reset the lamp time if the lamp is not replaced, as this could cause damage.