Filter
Top Products
TD-W8968 300Mbps Wireless N USB ADSL2+ Modem Router User Guide
Figure 4-120
¾ Refresh: Click the button, the information in the table will be updated.
¾ Back: Click the button, the screen will back to the previous page.
To configure the System Log settings:
Click the Configure System Log button (shown in Figure 4-119), you will see the screen below
(shown in Figure 4-121).
Figure 4-121
¾ Disable/Enable: Select the Enable to log the events, if you don’t want to log these events,
please select Disable.
¾ Log Level: Select the Log level in the drop-down list, for the Log level, all events above or
equal to the selected level will be logged.
¾ Display Level: Select the Display level in the drop-down list, for the Display Level, all logged
events above or equal to the selected level will be displayed.
¾ Mode: Select the mode to record the events. If the selected mode is Local, events will be
recorded in the local memory. If the selected mode is Remote, events will be sent to the
specified IP address and UDP port of the remote system log server. If the selected mode is
Both, events will be sent to the local memory and the remote system log server.
4.10.3 SNMP Agent
Choose “Management”Æ“SNMP Agent”, you can see the SNMP-Configuration screen as shown
below.
SNMP (Simple Network Management Protocol) has been widely applied in the computer networks
currently, which is used for ensuring the transmission of the management information between
any two nodes. In this way, network administrators can easily search and modify the information
on any node on the network. Meanwhile, they can locate faults promptly and implement the fault
diagnosis, capacity planning and report generating.
94