Filter
Top Products
TD-W8968 300Mbps Wireless N USB ADSL2+ Modem Router User Guide
This Advanced Setup section mainly introduces how to configure the modem router for adequate
use. The detailed explanations for each subsection are provided below.
)
Note:
To completely configure the WAN Interface, you need to first select the Layer2 Interface (4.4.1
Layer2 Interface
) according to the connection ISP provides for you, and then to select the type of
the connection (4.4.2 WAN Service) for the further configuration.
4.4.1 Layer2 Interface
Choose “Advanced Setup”Æ“Layer2 Interface”, and you can select WAN Service Interface
(layer2 interface) over ATM Interface or ETH Interface.
¾ ATM Interface: Configure the modem router to access Internet as an ADSL user. ISP
provides you VPI (Virtual Path Identifier), VCI (Virtual Channel Identifier) settings and the DSL
Interface with RJ11 connector. (Figure 4-2)
¾ ETH Interface: Configure the router to access Internet as an Ethernet user. ISP provides you
Broadband Internet Service and the Ethernet Interface with RJ45 connector.
17