Filter
Top Products
Basic Configuration via CLI
Trango Broadband Wireless — Access5830 User Manual Rev. F page 26
SU SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
SU Parameter Description Related CLI Command
radio will progress into
Opmode “SU” automatically
after reboot/power cycle.
Example:
#>set defaultopmode ap
Opmode Start Determines the amount of time
the radio will remain in
Opmode “OFF” after reboot
before progressing to the
default Opmode.
set defaultopmode su [<time (sec)>]
Example:
#>set defaultopmode su 60
IP
Subnet
Gateway
IP, Subnet, and Gateway
address of radio.
ipconfig [<new ip> <new subnet mask> <new
gateway>]
Example:
#>ipconfig 10.1.1.3 255.0.0.0 10.1.1.1
TFTPD TFTPD status (on or off).
TFTPD should be turned on to
import file into radio (such as
new firmware). Default is off.
TFTPD will revert to off after
reboot/power cycle.
tftpd [<on | off>]
RF TX Power Current transmit power of the
SU not including antenna gain.
This is controlled during the
association process.
Informational Parameter
Channel Scan Sequence Shows the various channels (in
sequence) that the SU will
scan while searching for an
AP.
freq writescan [<ch #> <h | v>]…
Example:
#>freq writescan 1 h 2 v 2 h 3 v
Active Channel Shows the channel used in the
current association, and
"Associated" or
"Disconnected" depending on
the association status.
Information Parameter
Broadcast Packet Filter This software switch (0)
enables/disables the blocking
of Ethernet control packets,
except ICMP and ARP, to
reduce the amount of
unnecessary overhead
introduced to the wireless link.
sw 0 [<on | off>] (default is on)
Example:
#>sw 0 on
AP Autoscan This software switch (1) is to
turn AP autoscan on or off.
sw 1 [<on | off>] (default is on)
TCP/IP for AP This software switch (2), when
on, allows users at the AP side
of the network to telnet or
HTTP into the SU.
sw 2 [<on | off>] (default is on)
TCP/IP for Local Ethernet This software switch (switch
6) when on, allows users on
the wired side of the SU to
telnet or HTTP into the SU.
sw 6 [<on | off>] (default is on)
Remarks User definable radio
information (i.e. customer
name, address of installation,
and so on). Maximum 28 of
characters can be stored.
remarks [<remarks>]
Example:
#>remarks 678 Oak Ave
Counters:
RF TX RF RX
Eth TX Eth RX
These are averages of wired
and wireless, transmit and
received, traffic in Kbps.
Informational Parameter