Filter
Top Products
Management
Trango Broadband Wireless — Access5830 User Manual Rev. F page 60
Command Description
AP/S
U Remarks
tftpd [<on | off>] enable or disable TFTPD service
time display current time Both
time <hh> <mm> <ss> set current time
<hh> = 0..23 <mm> = 0..59 <ss> =
0..59
AP
tm display current time mark Both
updateflash _loader+ For updating the radio’s loader
firmware.
Gets loader image from TFTP buffer
and writes to flash memory at loader
image section.
AP This command is rarely used
since the loader firmware does
not often require updating.
updateflash <mainimage | fpgaimage>
<current checksum> <new checksum>
For updating radio’s main firmware
or FPGA firmware. Gets firmware
image from TFTP buffer, verifies
checksum, and writes to flash
memory at main or FPGA image
section.
Both Examples:
updateflash mainimage 483985
1092844
updateflash fpgaimage 83383
393D38
uniimaxpower [<dBm>] set max TX power limit SU For M5830S-SU-EXT only.
Example: uniimaxpower 6
This command is used to set the
maximum power output of the
radio while it is operating in the
U-NII band.
updateflash sudb write current SU database into flash
memory at SUDB section
AP
updateflash systemsetting write current configuration into flash
memory at system configuration
section
Both same results achieved with
abbreviated command: save ss
ver displays firmware version info
1. version number and date
code
2. Firmware and FPGA
version code
3. Firmware and FPGA image
checksum
Both