Ultimate Technology 500 POS Mouse User Manual


 
27
Table 3. Local Mode Programming Instructions - Continued
Note: *Default Settings
Function Code(s) Operation Normal Indication Remarks
39
40
41
42
43
Keyswitch
Position 1
MAKE (38)
Keyswitch
Position 1
BREAK (39)
Keyswitch
Position 2
MAKE (40)
Keyswitch
Position 2
BREAK (41)
Keyswitch
Position 3
MAKE (42)
Keyswitch
Position 3
BREAK (43)
numeric keypad, enter applicable Function Code 38, 39, 40, 41,
42 or 43.
LED (2) flashes.
2. At the auxiliary keyboard, type the desired MAKE OR BREAK
key sequence shown below and /or desired key sequence. Note
that the maximum number of key codes is limited to 24 - this is
equivalent to approximately 12 key strokes.
<882>001 = To enter into secure mode or MAKE
<882>002 = To exit out of secure mode or BREAK
If the Series 500 Keyboard
beeps and LED (2) turns off
while entering key codes at
the auxiliary keyboard, you
have exceeded 24 key
codes. Repeat steps 1 and
2.
3. At the Series 500 Keyboard, press ENTER.
LED (2) turns off.
4. Program the next function code or exit programming mode by
entering 99 on Series 500 Keyboard numeric keypad or by
swiping the Programmer's card. If using the optional 3-position
keyswitch, move switch out of the AUX position.
44
Poll
Keyswitch
1. While in programming mode, at Series 500 Keyboard numeric
keypad, enter Function Code 44.
LED (2) turns on.
2. At Series 500 Keyboard numeric keypad, enter the applicable
number (0 or 1) to select polling method per list below.
0 = Send on change or transition
1 = Send only with poll command B7
LED (2) turns off.
3. Program the next function code or exit programming mode by
entering 99 on Series 500 Keyboard numeric keypad or by
swiping the Programmer's card. If using the optional 3-position
keyswitch, move switch out of the AUX position.