Filter
Top Products
47
Table 5. Remote Programming Mode Commands - Continued
OP
CODE
(HEX)
MNEMONIC/DESCRIPTION COMMAND/ACKNOWLEDGEMENT
B4 COMMIT
Writes programming changes to
the NVRAM. Always apply the
COMMIT command after
programming the keyboard to save
the changes in the NVRAM. Failure
to use the COMMIT command will
result in the loss of the changes the
first time power is removed from
the keyboard.
COMMAND: B4<CR>
B4 = Op Code
<CR> = terminate command (0D hex)
ACKNOWLEDGEMENT: NONE
B5 RESET
Resets keyboard after downloading
configuration. On receipt of this
command the unit does a warm
boot.
COMMAND: B5RST<CR>
B5 = Op Code
<CR> = terminate command (0D hex)
ACKNOWLEDGEMENT: NONE
B6 KSSND
Used to select when keyswitch 1, 2
or 3 MAKE/BREAK codes are
sent. Two options are available:
unsolicited mode where codes are
sent whenever the keyswitch is
rotated, or solicited mode where
codes are sent only when a OP
Code B7 command is received.
COMMAND: B6<CR>
B6 = Op Code
x A = unsolicited
B = solicited
<CR> = terminate command (0D hex)
ACKNOWLEDGEMENT: NONE
B7 KSSTATUS
Send keyswitch MAKE/BREAK
codes in current keyswitch 1, 2 or 3
position.
COMMAND: B7<CR>
B7 = Op Code
<CR> = terminate command (0D hex)
ACKNOWLEDGEMENT: NONE