Filter
Top Products
60
1. Disconnect keyboard from system.
2. Turn keyboard over to gain access to 5 screws that secure the base of the keyboard case to
the top. Remove the 5 screws.
3. Turn keyboard upright. Gain access to the battery by lifting the top portion of the keyboard
assembly from the base and placing it and the attached extended cable/connectors in front
of the base.
4. Remove existing battery.
5. Making sure to observe correct polarity, install a new 3-volt lithium battery in the keyboard
using one of the approved replacement batteries listed below, or an equivalent. Note that
sweat and oil can prevent a battery's terminals from making electrical contact. To avoid this,
wipe both sides before installing battery.
Panasonic, Part No. 884-0316
Eveready, Part No. 729-6010
Duracell, Part No. 737-0439
6. Make sure that the cable/connectors are making good contact, then position the top of the
keyboard assembly on the keyboard base. Turn the keyboard over and secure top of the
keyboard to the base by installing the 5 screws.
7. Connect keyboard to system.
8. Dispose of the used battery in an environmentally safe manner. If necessary, the battery may
be returned to the Ultimate Technology Corporation at the address shown below for proper
disposal.
Ultimate Technology Corporation
100 Rawson Road
Victor, NY 14564
CAUTION
Replacement of the battery may result in the need to reprogram
the keyboard. For programming instructions, refer to the
programming section of this manual.