Filter
Top Products
2. Press TRNSFR, and the smallest
empty channel number flashes on
the display.
3. Press E.
Note: • If you want to change the
channel, rotate the VFO.
• If the frequency you want to store exists already,
WARNING appears on the display and you will hear
a beep. (See “Duplicate Frequency Alert” on page
27).
RF Attenuation Feature
The BC250D comes with an RF Attenuation feature. If you're
near an unusually strong signal source, the signal may
overload the scanner. The scanner may stop repeatedly on
that signal and miss other transmissions.
The RF Attenuation feature works in all modes and attenuates
(reduces) the incoming signal strength to prevent stronger
signals from overloading the scanner.
The RF attenuation is set at the Menu mode.
1. Press MENU/BACK.
2. For Search mode, select 1:SERVICE OPTION /
:CHAIN SEARCH/4:ATTENUATOR / 1:ON by
rotating the VFO and pressing E.
OR
For Scan mode, select 2:SCAN OPTION /
1:CONVENTIONAL by rotating the VFO and pressing
E. Then select the channel number by rotating the VFO
and pressing E. Select 5:ATTENUATOR by rotating the
VFO and pressing E.
3. Select 1:ON by rotating the VFO and pressing E.
Note: Attenuation will only be active for the specified
channel. In Search mode, it is applied to the search
ranges in all banks.
Setting the Delay Mode for Frequency
The delay of 2 seconds is automatically set for each
frequency. To set the delay feature, enter into the Menu
mode.
1. Press MENU/BACK.
2. For Scan mode, select 2:SCAN OPTION /
32
HOLD/
MAN
SCAN
CH/
FRQ
MENU/BACK
L/O
.
SELECT
REVERSE
TRUNK
RSM
E
SEARCH
SERVICE
BC250D 11/6/2 11:36 AM Page 32