Filter
Top Products
1. Press MENU/BACK.
2. Select 3:SYSTEM OPTION /
7:DATA SKIP by rotating the VFO
and pressing E.
3. Select 1:ON by rotating the VFO and
pressing E.
When Data Skip is active, your scanner may pause
momentarily on an unwanted signal but will resume
searching in 2 or 3 seconds. The Data Skip feature is
active as well as Scan mode and Service Search mode.
Data Skip does not function during AM/WFM band Scan,
Chain Search for AM/WFM band, or WX Search, Priority
Scan, and Trunking mode.
Frequency Skip
If a particular frequency continues to interrupt search
scanning, it is possible to set your scanner to skip the
frequency.
To skip over a frequency, press L/O when stopping at the
frequency you want to skip or when in Search Hold mode.
Note: • You can program up to 200 skip frequencies.
The 201st skip frequency entered
causes the first skipped frequency
to unlock.
• If all frequencies in the search
range are set to skip, a beep
sounds and it moves to Search
Hold mode.
To resume searching:
1) Cancel the Frequency Skip set.
––– OR –––
2) Reset the Search Frequency range.
To cancel all skipped frequencies, press and hold
L/O for 2 seconds in Search Hold mode.
Storing Search Frequencies
You can quickly store any frequency you find during Search.
1. During Search, press HOLD/MAN to store or when the
scanner stops on the frequency you want to store.
38
SYSTEM OPTION
5:PC CONTROL
6:CLONE
7:DATA SKIP
HOLD/
MAN
SCAN
CH/
FRQ
MENU/BACK
L/O
.
SELECT
REVERSE
TRUNK
RSM
E
SEARCH
SERVICE
BC250D 11/6/2 11:36 AM Page 38