Filter
Top Products
77
5. Replace the cover and press down until it clicks into place,
and then turn ON the scanner.
APCO P25 CARD INSTALLED appears on the
display.
Installation is complete. You can monitor APCO Project 25
systems.
To use the P-25 card, you must program each channel for
Conventional mode or Trunking mode.
- Conventional mode–See “Storing Frequencies into Channels
in Menu Mode” pages 26-27.
- Trunking mode –“Programming and Receiving Digital and
Trunked Systems” pages 49-51.
Precautions for Installing the BCi25D Card
1. Do not touch the BCi25D card without first removing the
static electricity from your body. To do this, touch any
metal object to release static electricity build-up before you
touch the BCi25D card.
2. Turn OFF the scanner, before inserting the BCi25D card
into the slot.
3. Hold the BCi25D card by its edges when inserting it into
the slot.
4. Do not touch any of the terminals. The BCi25D is a
sensitive electrical device.
5. Do not operate with an open battery compartment cover.
This exposes the circuitry to dust and other environmental
particles that causes the unit to function improperly.
6. When you remove the BCi25D card, pull out the card by
the ribbon.
Turning ON/OFF the APCO P-25 Card
Once the P-25 Card has been installed, the P-25 Card will be
actively turned “ON”. To turn the P-25 Card “ON” or “OFF”
follow these instructions:
1. Press MENU/BACK.
2. Select 3:SYSTEM OPTION / 0:P-25 CARD by
rotating the VFO and pressing E.
3. Select 0:P-25 CARD / 1:ENABLE or 2:DISABLE
by rotating the VFO and pressing E for your desired
operation.
BC250D 11/6/2 11:37 AM Page 77