Uniden BC250D Scanner User Manual


 
71 for instructions.
STEP 1 is complete.
Note: Information on APCO P-25 Systems are referred to in
APCO Project 25 Reception on page 76.
STEP 2:
Programming Trunking Frequencies
After you finish selecting the bank and trunk type you want to
track, store the frequencies in the channels for your selected
bank in your scanner. Remember that you can only store one
trunking system in each bank.
Important: If you are programming an EDACS or LTR
trunked system, you must enter the frequencies
in a specific order. Check the frequency guide
included with the scanner for the frequencies in
your area. For additional frequencies, check the
web sites listed on page 11.
1. Press MENU/BACK.
2. Select 2:SCAN OPTION /
2:TRUNK by rotating the VFO and
pressing E.
3. Select the bank number by rotating the
VFO and pressing E.
4. Select 2:TRUNK CHANNEL and
enter the channel number by rotating the VFO and
pressing E.
5. Select 1:FREQUENCY and enter a frequency for the
trunked system using the keypad and pressing E.
6. Enter the alpha tag and press E. (See page 53).
7 You can also change the step size in this menu.(See page
103)
Note: To clear a mistake while entering the frequency,
50
HOLD/
MAN
SCAN
CH/
FRQ
MENU/BACK
L/O
.
SELECT
REVERSE
TRUNK
RSM
E
SEARCH
SERVICE
No. LCD display Icon TrunkingType Special requirements
1 Type 2 800 M Motorola Type 2 800 MHz
2 Type 1 M Motorola Type 1 a. Must program a fleet map.
3 Type 2 900 M Motorola Type 2 900 MHz
4 Type 2 UHF M Motorola Type 2 UHF b. Must program base, spacing,
5 Type 2 VHF M Motorola Type 2 VHF
frequency and offset channel.
6 EDCS WIDE E EDACS Wideband 9600 baud c. Must program frequencies
7 EDCS NARROW E EDACS Narrowband 4800 baud
in exact order and location.
8 EDCS SCT. E EDACS SCAT
9 LT L LTR
BC250D 11/6/2 11:37 AM Page 50