Filter
Top Products
[ 6 ]
BATTERY MAINTENANCE
Battery use time (per charge)
Fully charged (17-20 hours charge time)
• Up to 7 hours continuous use (up to 5 hours when the clarity booster is on)
• Up to 14 days when the handset is in the standby mode (up to 24 hours when in DirectLink mode)
Recharge your phone on a regular basis by returning the handset to the charger after each phone call.
MOUNTING THE BASE UNIT ON A WALL
You can mount your base directly to the wall. Before doing this, consider the following:
• Avoid electrical cables, pipes, or other items behind the mounting location that could
cause a hazard when inserting screws into the wall.
• Mount your phone within distance of a working phone jack.
• Make sure the wall material is capable of supporting the weight of the base and handset.
• Use screws with anchoring devices suitable for the wall material where the base unit will
be placed.
1) Insert two mounting screws into the wall (with their appropriate anchoring device),
10cm apart. Allow about 3mm between the wall and screwheads for mounting the phone.
2) Snap the desk top/wall mount bracket into the notches on the base bottom.
3) Plug the AC adapter into the AC ADAPTER jack on the telephone and then into a
Standard AC wall outlet.
4) Plug the telephone line cord into the TEL LINE jack on the telephone and then into
the telephone socket on the wall.
5) Align the mounting slots on the base with the mounting posts on the wall.
6) Then push in and down until the phone is firmly seated.
This phone also can be mounted on any standard telephone wall plate (for Australia).
1) Snap the desk top/wall mount bracket into the notches on the base bottom.
2) Refer to step 3 through 6 to mount the base.
3mm
10cm
35mm
UP308BH (DSS2465) ENG OM 1/14/05 11:44 AM Page 6