Filter
Top Products
[ 40 ]
Calling a party from the Caller ID list
From Standby mode
1) When the phone is in the standby mode, view the Caller
ID message (see “Viewing the Caller ID List” on page 38).
2) Press or . The displayed phone
number dials automatically.
From Talk mode
1) Press or .
2)
View the Caller ID message you want to dial (see “Viewing the Caller ID List” on page 38).
3) Press the DIAL soft key. The displayed phone number will be dialed.
Adding Zero to Caller ID message (New Zealand only)
While you review Caller ID information while the Insert Zero option is set to On, “0” is
inserted. Refer to page 21 “Setting Insert Zero (New Zealand only)” to set the Insert
Zero option to On or Off. New Zealand Telecom customers should leave Insert Zero to On.
Other New Zealand companies may require Insert Zero set to Off.
Storing Caller ID messages in the Phonebook
Messages shown in the Caller ID list can be stored in the phonebook. Using the incoming
call information (i.e., Caller ID list), the phone number and name of the party on the
Caller ID list can be stored in memory.
1) When the phone is in the standby mode, view the Caller ID message to be stored.
Then press the STORE soft key. “Store/Edit Name” appears.
2) To complete the setting, follow the steps 5-9 in “ Storing Phone Numbers, Names,
Distinctive Rings, and Speed dial” on page 30.
USING THE CALLER ID MESSAGE LIST
12/12 12:30AM
Jane Smith
0295979035
BACK DELETE STORE
• You cannot make a call
from the Caller ID list
if your phone is
connected to a private
branch exchange (PBX).
• If a call comes in via a
telephone system that
does not offer Caller ID
service, no information
is stored.
• If the Caller ID
message was received
as a private/unknown
number, or the
message does not
have the number,
you cannot store
the message in
the Phonebook.
• Even if the 100
memory locations are
full, the message will
be stored in the
Phonebook. However,
the message will be
erased from the Caller
ID list.
UP308BH (DSS2465) ENG OM 1/14/05 11:47 AM Page 40