Filter
Top Products
[ 36 ]
CHAIN DIALING
The memory locations in the handset are not limited to phone numbers. You can
also store a group of numbers (up to 20 digits), that you need to enter once your
call connects. This is referred to as Chain Dialing.
An example of this is a bank account number. Store a special number in the
phonebook location (refer to “Storing Phone Numbers, Names, Distinctive Rings and
Speed Dial” on page 29). Once you have called your bank, and when you are
prompted to enter the account number, just as you do when viewing the phonebook
location, view the special number, then press the DIAL soft key.
MEMORY DIALING (base only)
You can store 10 phone numbers in the base, and make calls with memory dialing
from the base.
Storing Phone Numbers
1) Press in the standby mode.
2) Enter the number you wish to store. (The number cannot exceed 20 digits.)
3) Press . Enter the memory location number (0-9) on the keypad.
You will hear a confirmation tone.
Deleting the Stored Data
1) Press in the standby mode.
2) Press again.
3) Enter the memory location number (0-9) you wish to delete.
You will hear a confirmation tone.
Making Calls with Memory Dialing
1) Press (talk) in the standby mode.
2) Press . Enter the memory location number (0-9) to dial the number.
• The 10 memory
locations in the base
are independent from
the handset.
• If you have not
pressed any key for
30 seconds, the
phone returns to the
standby mode.
• If you make or
receive a call, the
operation is canceled.
UP308BH (DSS2465) ENG OM 1/14/05 11:47 AM Page 36