Filter
Top Products
10-32 Command Reference
When a NETServer reboots, it copies configuration data from
the permanent configuration saved in flash memory to the
default configuration work area. The port is then reset, which
makes that configuration active. You can change the permanent
configuration by issuing one of the following commands, which
copy the default configuration to flash memory:
save s<port #>
save all
View the Ports Table
To view all of the S-ports, use the following command:
show all
Local Addr:192.77.206.57 Default Host: 0.0.0.0
Gateway: 0.0.0.0 Netmask: 255.255.255.0
Port Speed Mdm Host Type Status Input Output Pend
—— ——— —— ——————— ——— —————— ——— ——— ——
S0 9600 off Login/ COMMAND 1362 17663 2
S1 115200 on 192.77.203.5 Login/ IDLE 0 0 0
S2 115200 on 192.77.203.6 Login/ ESTABLISHED 1246 15842 0
S3 115200 on 192.77.204.26 Network/ ESTABLISHED 1757 43367 1
S4 115200 on Network/ IDLE 0 0 0
S5 115200 on 192.77.203.5 Login/ IDLE 0 0 0
S6 115200 on 192.77.203.5 Login/ IDLE 0 0 0
S7 115200 on 192.77.203.5 Login/ IDLE 0 0 0
S8 115200 on 192.77.203.5 Login/ IDLE 0 0 0
Port The number of each S-port.
Speed This displays the baud rate that the port is configured
for.
Mdm This field indicates whether Modem Control has been
enabled or not. See page 10-44 for more information
on Modem Control.