Filter
Top Products
U.S. Robotics SureConnect ADSL Ethernet/USB Router User Guide
negotiation starts only when the system identifies any traffic required to be transferred on the link.
In case the mode is set to DIRECT, the PPPoE negotiation is started manually using the
“pppoestart” command. The default mode is DIRECT.
-idletime <idletime> The value of idletime is given in minutes and this value indicates how long
the link remains up when there is no data transfer over the link. The idle time works only when
used in combination with mode AUTO. The default is 60 seconds.
-nat enable|disable Enables or disables NAT (Network Address Translation) for this PPP
interface. The default is for NAT to be disabled.
-netmask <mask> Specifies the netmask for the PPP interface. The mask is specified in dot
notation (i.e. 255.255.255.0).
-vpn <OUI> <vpnId> Specifies the VPN encapsulation. The OUI (Organizationally Unique
Identifier) and VPN identifier are specified as numbers.
Example:
pppoe 1 –o -if ppp0 -vpi 0 -vci 100 -user jones -pass Indiana
Defines a PPPoE profile. The ppp0 interface is used with the ATM connection vpi 0 and vci 100.
The user name is “jones” and the password is “Indiana”.
1.25.5 pppoestart
pppoestart <Profile>
Starts PPPoE given the specified profile. The profile is specified with an integer (0, 1, 2). The
profile was previously specified with the pppoe command.
pppoestop <Profile>
1.25.6 pppoestop
pppoestop <Profile>
Stops PPPoE given the specified profile. The profile is specified with an integer (0, 1, 2). The
profile was previously specified with the pppoe command.
pppoestop <Profile>
file:///P|/T_WRITER/Documentation/Released/9003%20(Guinness)/User%20Guide/9003%20(Guiness)%20prac%20template/cli.htm (65 of 71) [11/6/2002 8:58:46 AM]