Filter
Top Products
ViewSonic PJ502 8
Adjusting the projector's elevator
You can use the elevator feet to make adjustments if the surface on which you need to set
the projector is uneven or if you otherwise need to adjust the angle of projection. The adjust-
ment range of the elevator feet is 0 to 9 degrees.
1. After making sure that the projector is cool adequately, press and hold in the elevator but-
tons while holding the projector.
The elevator buttons and the elevator feet are on the both sides.
2. Raise or lower the projector to the desired height and the release the elevator buttons.
When you release the elevator buttons, the elevator feet will lock into position.
3. As necessary, you can also finely adjust the height of the projector by twisting the elevator
feet by hand.
WARNING
X Do not adjust the projector's elevator during use or immediately after use. Handling
while the projector is in a high temperature could cause a burn and/or malfunction to the
projector.
CAUTION
X If you press the elevator button without holding the projector, the projector might crash
down, overturn, smash your fingers and possibly result in malfunction. To prevent dam-
aging the projector and injuring yourself, always hold the projector whenever using the
elevator buttons to adjust the elevator feet.
X Except for inclining by the elevator feet adjustment, place the projector horizontally.
Elevator feet
Elevator button