Filter
Top Products
ViewSonic PJ502 15
Power on/off
NOTE. Turn the power on/off in right order. Please power on the projector before the
connected devices. Power off the projector after the connected devices
Turning on the power
1. Make sure that the power cord is firmly and correctly connected to the projector
and outlet.
2. Remove the lens cover, and set the power switch to the ON position.
The power indicator will light to solid orange. Then wait several seconds because buttons
may not function for these several seconds.
3. Press the STANDBY/ON (on the projector or the remote control) button.
The projector lamp will light up and the POWER indicator will begin blinking green.
When the power is completely on, the indicator will stop blinking light green.
To display the picture, select an input signal according to the section “Selecting an input
signal”.
Turning off the power
1. Press the STANDBY/ON (on the projector or the remote control) button.
The message “Power off?” will appear on the screen for approximately 5 seconds.
2. Press the STANDBY/ON (on the projector or the remote control) button again while the
message is visible.
The projector lamp will go off, and the POWER indicator will begin blinking orange.
Then the POWER indicator will stop blinking and light to solid orange when the lamp cool-
ing is complete.
3. Make sure that the power indicator lights to solid orange, set the power switch to the OFF
position. The POWER indicator will go off.
WARNING
X When the power is on, a strong light is emitted. Do not look into the lens or vents of
the projector.
POWER
indicator
STANDBY / ON
button
Power switch
(On position)
(Off position)
STANDBY / ON
button