Wacom 15X Projector Accessories User Manual


 
13
Connect the power supply to Cintiq. See C Then connect the supply’s power cable and plug
the supply into an AC outlet. See D
S T E P 1 : L C D D I S P L A Y I N S T A L L A T I O N
Cintiq can be used alone or with another display, such as a CRT monitor or LCD projector. To use
Cintiq with another display, you will need two video cards or a video card with dual output.
Depending on the capabilities of your video card and operating system, you may be able to set up
Cintiq as a mirrored, extended, or independent display. Refer to your video card documentation
for more information on its capabilities.
In the first stage of the installation process you will install Cintiq as a display on your system.
As you work through the first stage of the installation process, please refer to the LCD Display
Cabling Diagram on the following page when making cable connections.
Important: Do not connect the USB or serial data cable until instructed to do so.
Turn off your computer.
Caution: Never connect or disconnect the video or power cable while your computer or
Cintiq are powered on—this can damage the LCD display or video card.
If your computer has only one video connector, you will need to unplug your previous dis-
play. Determine if your computer has a digital (DVI-I, DVI-D, or ADC) or analog (VGA)
connector, and set the Digital/Analog (DVI/VGA) switch located on the back of Cintiq for the
video connection you are using. Move the switch down for Digital (DVI-I, DVI-D, or ADC),
and move it up for Analog (VGA). See A
DVI-I Connector
DVI-D Connector
Apple ADC Connector
VGA Connector
If you are connecting to a DVI-I or DVI-D connector, plug one
end of the DVI to DVI cable into Cintiq, and the other end into your
computer’s video card.
If you are connecting to an ADC connector, you will need to
obtain an ADC to DVI adaptor. Plug one end of the DVI to DVI
cable into Cintiq. Next, plug the other end of the cable into the
ADC to DVI adaptor. Then plug the ADC adaptor end into the ADC
connector on your video card.
If you are connecting to a VGA connector, plug the DVI end of
the VGA to DVI cable into Cintiq. Then plug the VGA end of the
cable into the VGA connector on your video card.
Be sure to tighten the thumbscrews on the connectors. See B