Filter
Top Products
3-4
APS-8M Asynchronous Port Switch; User’s Guide
5. Exit Command Mode: At the "APS>" command prompt, type /X and
press [Enter]. The APS-8M will exit command mode.
6. Access Command Mode via Modem: From a PC with a modem and
Telco line, dial the number for the line which is connected to the
APS-8M’s internal modem. Once the connection is established, the unit
should send the "APS>" command prompt, indicating that you have
successfully accessed command mode.
Note: If a password that permits access to Supervisor Mode has been
previously defined, a prompt will be displayed. Key in a Supervisor
Level password, and press [Enter]. If a Supervisor Level password has
not yet been defined, the prompt will not be displayed.
a) Type
/H and press [Enter] to display the Help Menu. If desired,
you may also wish to repeat the Port Connection / Disconnection
examples described in Step 4 above.
b) When you have finished communicating with the APS-8M unit,
type /X and press [Enter] to exit command mode and terminate the
modem connection to the unit.
This completes the Quick Start Guide for the APS-8M. Please proceed to
Sections 4 and 5 for complete installation and configuation procedures.