Filter
Top Products
5-6
APS-8M Asynchronous Port Switch; User’s Guide
5.4.1.1. Adding Passwords
The "Add Name/Password" menu is used to create new user accounts
and add passwords to the password directory. To access the Add Name/
Passwords menu, activate the Edit Password Directory Menu as described in
Section 5.4.2, then type 1 and press [Enter]. The Add Name/Password menu
will be displayed as shown in Figure 5.3. The Add Name/Password Menu
allows you to assign the following parameters:
1. Name: Assigns a username to the password. Note that usernames are not
required when logging into command mode, and are used for descriptive
purposes only.
2. Password: After keying in the password, the unit will prompt you to
verify the password by re-keying it.
3. Dial Back #: Defines the number that the APS-8M will dial when the
Dial Back feature is enabled and the unit is contacted via modem. For
more information on the Dial Back Mode, please refer to Section 5.4.2.
4. Dial Back Mode: Enables/Disables the Dial Back Mode for this
password. For more information on the Dial Back Mode, please refer to
Section 5.4.2.
5. Supervisor Mode: Enables/Disables Supervisor Mode for this password.
When Supervisor Mode is enabled, the password will provide access
to all configuration menus, and allow connections to all ports. When
Supervisor Mode is disabled, the password will not permit access to
configuration menus, and will only allow access to ports specifically
permitted by the password definition.
Note: In order to access Supervisor Mode from any given port,
the port at which the password is issued must also permit Supervisor
Commands.
ADD NAME/PASSWORD:
1. Name: (undefined)
2. Password: (undefined)
3. Dial Back #: (undefined)
4. Dial Back Mode: Off
5. Supervisor Mode: Off
6. Port Access: None
7. Save Entry
Enter: #<CR> to select,
<ESC> for previous menu ...
Figure 5.3: The Add Name/Password Menu (Defaults Shown)