Filter
Top Products
Location, Mounting and Ventilation
TM-DIOP-01XN-01 2-5
Location, Mounting and Ventilation
When you install the Inverter into a rack, allow cooling air to reach the
ventilation inlets. At the same time, do not block the air exhaust. See
“Electrical Specifications” on page A–2 for the operating altitude
specification and the operating ambient temperature range measured at
the unit case.
The inverter is designed to fit into a standard 19 in. (483 mm) equipment
rack. Mounting brackets are included which allow the unit to be mounted
in either cabinet style racks or relay racks.
Installation Into Cabinet Style Equipment Racks
For installation into a cabinet style equipment rack, the backplane is
secured using two sliding rails as shown below.
Figure 2-4
Installing into Cabinet Style Racks
2. Assemble the Backplane1. Assemble the Sliding Rails
3. Secure the Backplane