Filter
Top Products
Remote Communication & Monitoring
4-4 TM-DIOP-01XN-01
How to Setup For the First Time
Hardware Setup
In order to communicate to the XDI Ethernet for the first time, you will
need a CAT5/CAT5e cable and a computer with an Ethernet adapter
installed.
Setting up to configure for the first time:
1. Wire up the rack mount assembly as stated in Chapter 2.
2. Connect to the unit as shown in Figure 4-2, “First Time Setup
Connections” on page 4–4.
3. Turn on the inverter.
4. Configure the computer’s Ethernet adapter settings (contact Network
Administrator).
5. Open your Web browser and go to the default IP address (Table 4-1).
Figure 4-2
First Time Setup Connections
Inverter
Inverter
Hub
PC
PC
Special cross-over cable required
Network Setup (PC to
Inverter)
Network Setup (PC to Hub to
Inverter)
OR