XEROX WIDE FORMAT COPY SYSTEM Special features keys • 75
value. Any such change will be applied to that printing of the
entire set.
8. Enter the number of copies desired and press the
Start key.
The Printer prints the number of sets requested.
After the printing of the set, the set can be recalled, the values changed
again, and the set reprinted using the new values. To recall the set, refer
to “Store/Recall key” in the “Special features key” section of this manual
for further information.
NOTE: Settings for the last document scanned are not restored when
recalling a set. After a set is recalled, all LED’s will be turned off. If a
setting is changed after a set is recalled, it will be applied to all
documents in the set.
Batch key
The Batch feature allows you to improve copy speed by enabling Batch
Mode processing of several documents on the Scan System. When
Batch Mode processing is enabled, the Scan System collects prescan
information for just the first document inserted into the Scan System.
Prescan information on subsequent documents in the set is not
collected. The subsequent documents will be scanned using the
information collected on the first document. Eliminating the collection of
this information increases overall copy speed.
To enable Batch Mode processing:
1. Press the
Batch key. The Batch indicator lamp will begin
flashing.
2. Insert the first original into the Scan System. The Scan System
scans the original and the screen shown below is displayed.
WIDTH FOUND FOR SE T IS XX.X
INP UT AN OTHER W ID TH OR
PRESS ENTER TO ACCEPT
Width Found for Set is XX.X Screen
3. Do one of the following:
Use the numeric keypad to enter the width of the set and
press the
Enter key to accept the value.
Press the Enter key to accept the width detected by the
WIDE FORMAT COPY SYSTEM.
The Batch indicator lamp becomes steady and remains so
until batch mode is disabled.
4. When the last document in the set has been scanned, press the
Batch key to disable batch mode. The Batch indicator lamp is
extinguished.