Filter
Top Products
Page 2-4 Xerox WorkCentre PE120i System Administration Guide
Basic Network Installation
Enabling or Disabling TCP/IP
At the WorkCentre PE120i, perform these steps:
1
¾ Press [Menu] until you see
Network Setup on the top line of
the display.
8. Network Setup
[Reset Network]
2
¾ Press or until Configure
Network is displayed and press
[Enter].
8. Network Setup
[Config. Network]
3
¾ Press or until TCP/IP is
displayed and press [Enter].
Config Network
[TCP/IP]
4
¾ Press or until Setup is
displayed and press [Enter].
¾ To enable TCP/IP, press or
until Enable is displayed and
press [Enter]. Otherwise display
Disable and press [Enter].
TCP/IP
[Setup]