Filter
Top Products
Xerox WorkCentre PE120i System Administration Guide Page 2-5
Basic Network Installation
Network Communication Setup
Automatically setting TCP/IP Addresses
At the WorkCentre PE120i, perform these steps:
After a short period of time, the network will allocate the required addresses.
Print a System Data sheet to check the addresses (see Printing a System Data2-6).
1
¾ Press [Menu] until you see
Network Setup on the top line of
the display.
8. Network Setup
[Reset Network]
2
¾ Press or until Configure
Network is displayed and press
[Enter].
8. Network Setup
[Config. Network]
3
¾ Press or until TCP/IP is
displayed and press [Enter].
You can use DHCP or BOOTP
to automatically configure TCP/
IP on the machine.
Config Network
[TCP/IP]
4
¾ Press or until the
required setting method is
displayed and press [Enter].
TCP/IP
[DHCP]
5