Filter
Top Products
Xerox WorkCentre PE120i System Administration Guide Page 7-3
Local Connection
Installation Procedure
There are four drivers provided, PCL6, PostScript, Twain and ControlCentre. The installation
procedure is the same for all of them. You can install many of the drivers that you require at
the same time.
NOTE: The drivers will be installed to the local port. For network connections, it is
recommended that you use the instructions relevant to the specific network
requirements.
The WorkCentre PE120i can be connected directly to the parallel port or USB of a host
workstation. A document file can be sent or received from the host workstation via the
appropriate port to the WorkCentre PE120i.
There are three stages required to install the WorkCentre PE120i on a port on a local
workstation:
¾ Install the driver.
This requires the appropriate printer driver to be installed on the workstation.
¾ Workstation Setup
This requires the workstation to be configured to print to the WorkCentre
PE120i.
¾ Test Print or Scan
A print job should be submitted to ensure the WorkCentre PE120i has been
installed and configured correctly.